STEVAL-IHM034V2

NRND
MySTに保存する

Dual motor control and PFC demonstration board featuring the STM32F103 and STGIPS20C60

データブリーフのダウンロード
概要

製品概要

概要

概要

The STEVAL-IHM034V2 is a complete motor control kit solution for the evaluation of STMicroelectronics® wide product portfolio tailored to applications where it is necessary to drive, simultaneously, two motors in sensorless field oriented control (FOC) and perform active power factor correction (PFC) through digital control of a single-stage boost DC-DC converter.

Typical applications include in-room air conditioners (RACs), where this ST solution can drive the compressor, outdoor fans and PFCs. The microcontroller unit consists of STMicroelectronics’ ARM™ Cortex-M3 core-based STM32F103RC, which is capable of carrying out all of the previously-mentioned tasks simultaneously. The board is compatible with the STM32F2 series and with the ARM™ Cortex-M4 core-based STM32F4 series.

Motor 1 is powered by the onboard SLLIMM™ (small low-loss intelligent molded module) STGIPS20C60. Motor 2 can be powered by an external STMicroelectronics power stage, such as those that can be evaluated using the STEVAL-IHM021V1, STEVAL-IHM024V1, STEVAL-IHM032V1 or STEVAL-IHM035V1 evaluation boards. Simultaneously, the same microcontroller unit drives the onboard boost PFC stage designed with the STGW35HF60W ultrafast IGBT or, alternatively, for high switching frequencies the STW38N65M5 MDmesh V Power MOSFET, and STTH15R06D Turbo2 ultrafast diode or the STPSC1206D Schottky silicon carbide diode.

The STEVAL-IHM034V2 can be used together with the STM32 permanent magnet synchronous motor (PMSM) single/dual FOC software development kit (SDK) v3.2 or later and its compatible PFC v1.0 firmware plug-in.

  • 特徴

    • Nominal power 1300 W, max. power 1700 W
    • Digital PFC section:
      • Single-stage boost converter based on the STGW35HF60W (or STW38N65M5) and STTH15R06D or (STPSC1206D)
      • AC mains current sensing
      • DC bus voltage sensing
      • Hardware overcurrent protection
      • Hardware overvoltage protection
      • AC mains voltage zero crossing detection
      • Rectified AC mains voltage sensing
      • External boost inductor
    • Inverter section (motor 1 drive):
      • IGBT intelligent power module STGIPS20C60 in SDIP 25L molded package
      • 3-shunt or DC link motor current sensing
      • Hardware overcurrent protection
      • Heatsink temperature measurement
      • Overcurrent protection disabling network
    • Control section:
      • Centralized dual motor control and PFC drive, using the STM32F103RCT6
      • MC connector to drive the second motor power stage (a compatible power board, such as the STEVAL-IHM021V1, STEVAL-IHM024V1, or STEVAL-IHM032V1, can be plugged here)
      • SWD programming and debugging
      • JTAG programming
      • Opto-isolated USART communication
    • Other functions:
      • User key, reset, potentiometer, user LED, NTC relay, test points
    • Power supply:
      • +15 V, +3.3 V power supply
    • RoHS compliant

おすすめ製品

STSW-STM32100

STM32 PMSM FOC Software Development Kit - MC library (UM1052)

製品

検索履歴

ブックマーク

Please log in  to show your saved searches.

▼
戻る
戻る
戻る

ご存知でしたか？

Please provide email

Please enter code

Congratulations!

Simple subscription

Congratulations!

x

You can start following this product to receive updates when new Resources, Tools and SW become available. It's easy and takes only 1 minute. ja

You can start following this product to receive updates when new Resources, Tools and SW become available. It's easy and takes only 1 minute. ja

You can start following this product to receive updates when new Resources, Tools and SW become available. It's easy and takes only 1 minute. ja

Invalid code, please check the code sent to your email address and validate again. In case you did not receive any code please select 'I did not receive code'

You can start following this product to receive updates when new Resources, Tools and SW become available. It's easy and takes only 1 minute. ja

STによるお客様のプロファイル情報の処理方法、またお客様がご自身の個人情報の保護に関する権利を行使する方法については、当社の プライバシー･ステートメント をご確認ください。

以下の製品のお知らせを受け取れます
- STEVAL-IHM034V2

You can re-use the validation code to subscribe to another product or application.

Sorry, there was a problem on our servers. Please try again.
The current status of a product:
Active: Product is in volume production
Evaluation: Product is under characterization. Limited Engineering samples available
Preview: Product is in design stage
Target: Product is in design feasibility stage.No commitment taken to produce
Proposal: Marketing proposal for customer feedback.No commitment taken to design or produce
NRND: Not Recommended for New Design.Product is in volume production only to support customers ongoing production.Marketing description of the package type.Compliancy of the device with industry requirement domains (IRD)The RoHS status of a product:
ECOPACK 1: Initial grade to identify European RoHS compliant products.
ECOPACK 2: New grade to identify brominated chlorinated and antimony oxide flame retardant free products.
ECOPACK 3: Halogen free RoHS exemptions free products.
(*): ECOPACK 2 version available upon request.
(**): Some versions still existing in ECOPACK 1 or not compliant.Compliancy with WEEE Directive (2012/19/EU)The current status of a product:
Active: Product is in volume production
Evaluation: Product is under characterization. Limited Engineering samples available
Preview: Product is in design stage
Target: Product is in design feasibility stage.No commitment taken to produce
Proposal: Marketing proposal for customer feedback.No commitment taken to design or produce
NRND: Not Recommended for New Design.Product is in volume production only to support customers ongoing production.Budgetary PriceMain country of assembly or fabrication of the product.ECCNs are five character alpha-numeric designations used on the Commerce Control List to identify dual-use items for export control purposes. ECCNs are five character alpha-numeric designations used on the Commerce Control List to identify dual-use items for export control purposes.