ST7LITE49M

已停产

8-bit MCU

下载数据手册

产品概述

描述

The ST7LITE49M is a member of the ST7 microcontroller family. All ST7 devices are based on a common industry-standard 8-bit core, featuring an enhanced instruction set.

The ST7LITE49M features Flash memory with byte-by-byte in-circuit programming (ICP) and in-application programming (IAP) capability.

Under software control, the ST7LITE49M device can be placed in Wait, Slow, or Halt mode, reducing power consumption when the application is in idle or standby state.

The enhanced instruction set and addressing modes of the ST7 offer both power and flexibility to software developers, enabling the design of highly efficient and compact application code. In addition to standard 8-bit data management, all ST7 microcontrollers feature true bit manipulation, 8x8 unsigned multiplication and indirect addressing modes.

The ST7LITE49M features an on-chip Debug Module (DM) to support in-circuit debugging (ICD). For a description of the DM registers, refer to the ST7 ICC protocol reference manual.

  • 所有功能

    • Interrupt management13 interrupt vectors plus TRAP and RESET
    • A/D converter: 10 input channels
    • Development toolsFull HW/SW development packageDM (Debug Module)
    • Memories4 Kbytes single voltage extended Flash (XFlash) Program memory with Read-Out Protection In-circuit programming and in-application programming (ICP and IAP) Endurance: 10k write/erase cycles guaranteed Data retention: 20 years at 55 °C384 bytes RAM128 bytes data EEPROM with Read-Out Protection. 300K write/erase cycles guaranteed, data retention: 20 years at 55 °C.
    • I/O PortsUp to 24 multifunctional bidirectional I/Os8 high sink outputs
    • Clock, reset and supply management3-level low voltage supervisor (LVD) for main supply and an auxiliary voltage detector (AVD) for safe power-on/offClock sources: Internal trimmable 8 MHz RC oscillator, auto-wakeup internal low power - low frequency oscillator, crystal/ceramic resonator or external clockFive power saving modes: Halt, Active-halt, Auto-wakeup from Halt, Wait and Slow
    • Communication interface:I²C multimaster interface
    • Instruction set8-bit data manipulation63 basic instructions with illegal opcode detection17 main addressing modes8 x 8 unsigned multiply instructions
    • 5 timersConfigurable watchdog timerDual 8-bit Lite timers with prescaler, 1 real-time base and 1 input captureDual 12-bit Auto-reload timers with 4 PWM outputs, input capture, output compare, dead-time generation and enhanced onepulse mode functions