ALED7709

概述

开始

Partner products

銷售公文包

Please enter your desired search query and search again

产品概述

描述

ALED7709x are automotive-grade (AEC-Q100 Grade1 qualified) LED drivers combining a boost/SEPIC controller and four low-side constant-current sinkers, designed to drive strings of high brightness LEDs. The switching converter section provides the supply rail for the LED strings, whose value is constantly optimized for maximum efficiency. The boost/SEPIC controller supports the external synchronization and spread spectrum. ALED7709x can work simultaneously or exclusively in standalone mode (SAM), controlled only by PWMI signal, and in bus driven mode (BDM) through an I²C serial interface. The brightness of the four LED strings can be controlled either in global or local mode. In global mode, the ALED7709x supports a mixed PWM and analog dimming to improve the brightness range capability. Only the BDM provides full access to ALED7709x advanced features. PWM dimming frequency can be programmed changing the setting of the internal 16-bit counter, while an internal oscillator avoids the use of an external clock source.

The ALED7709A is dedicated to BDM while ALED7709B is more suitable for SAM. ALED7709x implement basic protections (overvoltage, overcurrent, and thermal shutdown) as well as “Open and Short” LED fault detection, with optional channel auto-disconnect in case of fault.

The devices support an optional P-channel MOSFET in series to the input. It protects the system, LED strings and channels in case of some faulty conditions, output short-to-ground or excessive input voltage transients and it also reduces the power consumption when in standby.

所有功能
AEC-Q100 Grade1 qualified

Operating temperature range -40 °C < T_J < 150 °C

4.5 V to 42 V operating input voltage range

Up to 60 V tolerant for load dump @ 24 V battery

Supports battery cranking events down to 4 V supply

Simultaneous or exclusive control by PWMI and I²C interface

Switching controller section

Low shutdown current: I_SHDN < 15 µA

Fixed frequency peak current-mode controller

Cycle-by-cycle power switch OCP

Adjustable (250 kHz to 2.2 MHz) switching frequency with optional spread spectrum

Synchronized boost and SEPIC topologies support

Line switch control for standby power saving and inrush current protection

Input overvoltage and output short-circuit protection

LED strings control section

4 x 40 V rated constant current outputs

Adjustable up to 200 mA per channel

±2% typ. output current accuracy

Mixed PWM and Analog dimming

100 Hz to 12.8 kHz dimming frequency

Dimming ratio 10000:1 at 100 Hz

LED temperature sensor (NTC) management

Selectable channels phase-shifting and adjustable Rise/Fall time for reducing EMI

Open channel, LED short-circuit detection

Two versions available: ALED7709A and ALED7709B
阅读更多阅读较少信息

eDesignSuite

eDesignSuite is a comprehensive set of easy-to-use design-aid utilities ready to help you streamline the system development process with a wide range of ST products.

Choose design tool:

Power Management Design Center

Power Supply Design Tool

• SMPS design, by topology, by type and by product

• PFC design with analog and digitial control

• Supports various PCB configurations

Choose type:

DC/DC

AC/DC

太阳能电池充电器

Power Management Design Center

Digital Power Workbench

• Provides a step-by-step optimized design of power section and control loop

• Generates the STM32Cube embedded software package for custom applications and allows firmware project generation, compatible with multiple STM32 IDEs

Power Management Design Center

Power Tree Designer

• Specify input/output power for each node in the tree

• Check for consistency

• Design each individual node

Choose design tool: