ST25TV02K

产品概述

描述

ST25TV02K and ST25TV512 are NFC/RFID tag ICs with a tamper-proof feature, and specific modes to protect tag access, such as Untraceable mode.

These devices feature a digital signature used to prove the origin of the chip in cloning detection, embed a configurable EEPROM with 60-year data retention, and can be operated from a 13.56 MHz long-range RFID reader or an NFC phone.

The contactless interface is compatible with the ISO/IEC 15693 standard and NFC Forum Type 5 tag.

所有功能
Contactless interface

Based on ISO/IEC 15693

NFC Forum Type 5 tag certified by the NFC Forum

Supports all ISO/IEC 15693 modulations, coding, subcarrier modes and data rates

Custom Fast read access up to 53 Kbit/s

Single and multiple block reads

Single block writes

Internal tuning capacitance: 23 pF, 99.7 pF

Proprietary Inventory commands for speeding up the inventory process

内存

Up to 2 Kbits of EEPROM

RF interface accesses blocks of four bytes

Write time from RF: typical 5 ms for one block

Data retention: 60 years

Minimum endurance: 100 k write cycles

16-bit event counter with anti-tearing

Data protection

User memory: two or three areas, read and/or write protected by two 32-bit encrypted passwords for three areas or one 64-bit encrypted password for two areas

System configuration: write protected by a 32-bit encrypted password

Permanent write locks at a block level

Product identification and protection

Kill mode and untraceable mode

Tamper detect capability (patent pending)

TruST25 digital signature

EAS (electronic article surveillance) capability

Privacy protection

Consumer privacy can be protected through the following features:
Kill mode
Untraceable mode

In association with:
Passwords with cover coding
Data and configuration locks (permanent or temporary)

Temperature range

From - 40 to 85 °C

包

Sawn and bumped wafer, ECOPACK2 (RoHS compliant)

5-pin package, ECOPACK2 (RoHS compliant)

Compatibility ST25TV02K / LRI2K

Full compatibility in terms of functionality and capacitances with two exceptions:
Kill command requires option_flag to be set to 0
Error codes and error generation can be different on a per command basis
阅读更多阅读较少信息

eDesignSuite

eDesignSuite is a comprehensive set of easy-to-use design-aid utilities ready to help you streamline the system development process with a wide range of ST products.

Choose design tool:

Power Management Design Center

Power Supply Design Tool

• SMPS design, by topology, by type and by product

• PFC design with analog and digitial control

• Supports various PCB configurations

Choose type:

DC/DC

AC/DC

太阳能电池充电器

Power Management Design Center

LED Lighting Design Tool

• Handles AC-DC and DC-DC design in common topologies

• Displays interactive and annotated schematic

• Provides current/voltage graphs, Bode plots, efficiency curves and power-loss data

Choose type:

DC/DC

AC/DC

Power Management Design Center

Digital Power Workbench

• Provides a step-by-step optimized design of power section and control loop

• Generates the STM32Cube embedded software package for custom applications and allows firmware project generation, compatible with multiple STM32 IDEs

Power Management Design Center

Power Tree Designer

• Specify input/output power for each node in the tree

• Check for consistency

• Design each individual node

Choose design tool: